Rear fender
The rear fender is attached with three screws and has a cable attached to the motherboard. You start by unscrewing the 3 screws that are easily accessible on the top of the rear fender. Then you have to unscrew the screws on the cover under the stand plate. When the cover has come loose, you will then have the opportunity to disconnect the cable from the motherboard so that the back shield will come loose.
The installation of the new rear fender is then done in the same way. You connect the cable to the motherboard, screw the cover back under the stand plate and then screw in the 3 screws on the top of the rear fender.
Help video to change rear fender:
The procedure for E2S JUNIOR in this video is the same as for E2S V1. Therefore, a model other than E2S JUNIOR is used in this video.
Front screen
Replacement of the front fender is done by removing the reflective stickers on the outside of the rim. Then unscrew the screws so that the small covers come loose. You then need an 18mm wrench to loosen the nut on both sides. The rim with tires will then loosen and you will have access to unscrew the screw that is attached to the underside of the front fender, you will need an unbrako to loosen on this screw.
The front fender will then come loose and you have the option of mounting the new front fender.
Help video for changing the front screen:
The procedure for E2S JUNIOR in this video is the same as for E2S V1. Therefore, a model other than E2S JUNIOR is used in this video.
Was this article helpful?
Articles in this section
- Replacing display E2S JUNIOR
- changing battery and motherboard - E2S JUNIOR
- changing to a puncture-free tire
- correction of skewed fork E2S junior
- Changing front fender and rear fender E2S junior
- Changing handlebars E2S junior
- Changing tire and hose E2S Junior
- changing the accelerator pedal - E2S junior
- tightening brake E2S junior
- tightening the folding mechanism E2S Junior