How to tighten the brake:
Loosen the screw on the pendulum located at the brake wire.
Then push this further into the wire.
Tighten the screw again.
Necessary tools:
5 mm unbrako
You can find a video demonstrating the tightening of the brakes on the E2S V2 by clicking on the link below. The brake on the E2S V2 PRO is tightened in the same way.
1
-1
Was this article helpful?
Articles in this section
- Changing handlebar - E2S V2 Pro
- Correcting fork and handle - E2S V2 Pro
- Changing brake lever E2S V2 Pro
- Change acceleration pedal E2S V2 Pro
- Digital user manual E2S V2 pro
- Changing tire and hose E2S V2 Pro
- Tightening folding mechanism E2S V2 Pro
- Changing to a puncture free tire - E2S V2 Pro
- Changing battery and motherboard E2S V2 Pro
- Changing front screen and rear screen E2S V2 Pro